Dell EMC PowerEdge T440 Technical Specifications Regulatory Model: E30S Series Regulatory Type: E30S002 December 2020 Rev.
Notes, cautions, and warnings NOTE: A NOTE indicates important information that helps you make better use of your product. CAUTION: A CAUTION indicates either potential damage to hardware or loss of data and tells you how to avoid the problem. WARNING: A WARNING indicates a potential for property damage, personal injury, or death. © 2017 - 2018 Dell Inc. or its subsidiaries. All rights reserved. Dell, EMC, and other trademarks are trademarks of Dell Inc. or its subsidiaries.
Contents Chapter 1: Technical specifications............................................................................................... 4 System dimensions..............................................................................................................................................................4 Chassis weight.....................................................................................................................................................................
1 Technical specifications The technical and environmental specifications of your system are outlined in this section.
Table 1. Dimensions of Dell EMC PowerEdge T440 system Xa Xb Ya Yb Yc Za Zb Zc 218 mm (8.58 in) 307.9 mm (12.12 in) 430.3 mm (16.94 in) 443.3 mm (17.45 in) 471.333 mm (17.37 in) (with bezel) 37.065 mm (1.45 in) 538.4 mm (21.19 in) 573.636 mm (22.58 in) (without bezel) 21.165 mm (0.83 in) Chassis weight Table 2. Dell EMC PowerEdge T440 Chassis weight System configuration Maximum weight 4 x 3.5-inch drive system (no longer offering) 23 Kg (50.71 lb) 8 x 3.5-inch drive system 29.3 Kg (64.
Table 3.
Drive specifications Drives The Dell EMC PowerEdge T440 system supports: ● 4x3.5 configuration (no longer offering): Up to 4 SAS or SATA drives/Nearline SAS drives ● 8x3.5 configuration: Up to 8 SAS or SATA drives/Nearline SAS drives ● 16x2.5 configuration: Up to 16 SAS or SATA drives Optical drive and tape drive The Dell EMC PowerEdge T440 system supports: ● one optional slim SATA DVD-ROM drive or DVD +/-RW drive ● internal tape drives LTO5, LTO6, LTO7 and external SAS drives.
IDSDM or vFlash card The Dell EMC PowerEdge T440 systemIDSDM module contains both Internal Dual SD Module (IDSDM) and vFlash card that are combined into a single card module. The following are options available for PowerEdge T440 system: ● VFlash only ● IDSDM only ● vFlash + IDSDM Video specifications The Dell EMC PowerEdge T440 system supports Matrox G200eW3 graphics card with 16 MB capacity. Table 6.
Table 9. Maximum vibration specifications Maximum vibration Specifications Operating 0.26 G rms at 5 Hz to 350 Hz (all 3 axes). Storage 1.88 G rms at 10 Hz to 500 Hz for 15 min (all six sides tested). Table 10. Maximum shock specifications Maximum shock Specifications Operating Six consecutively executed shock pulses in the positive and negative x, y, and z axes of 6 G for up to 11 ms.
Table 14. Expanded operating temperature specifications (continued) Expanded operating temperature Specifications For temperatures 40°C–45°C, derate maximum allowable temperature by 1°C per 125 m above 950 m (1°F per 228 ft). NOTE: When operating in the expanded temperature range, system performance may be impacted. NOTE: When operating in the expanded temperature range, ambient temperature warnings may be reported in the System Event Log.
Particulate and gaseous contamination specifications The following table defines the limitations that help avoid any equipment damage or failure from particulate and gaseous contamination. If the levels of particulate or gaseous pollution exceed the specified limitations and result in equipment damage or failure, you may need to rectify the environmental conditions. Remediation of environmental conditions is the responsibility of the customer. Table 16.
