Setup Guide

7. Remove the cooling-fan assembly.

Figure 5. Removing and Installing the Cooling-Fan Assembly

1. release levers (2) 2. cooling-fan assembly

3. cooling fans (6) 4. cooling-fan connectors (6)

5. support brackets (2)

8. For the 2.5" hard-drive chassis, remove the SAS cables from the system board and the backplane

expander board.

NOTE: The next steps are applicable for the 3.5” hard drive chassis only. If you have a 2.5” hard

drive chassis, go to the next section Installing the Contents of the Upgrade Kit.

9. Remove the SAS cables from the backplane expander board .

10. Rotate the release lever outward to disengage the backplane expander board connectors from the

connectors on the hard-drive backplane.