Reference Guide

Replace the DPE (svc_replace_dpe)
This service script is used to perform a DPE replacement. The node must be in service mode to run the script.
WARNING: Only trained service personnel should use this script.
Ensure that the following conditions are met before running this script:
● Only one node should be installed in the DPE.
● The system type must have been set using the Post Utilities.
● After setting the system type, the node should be rebooted.
The node reboots into service mode.
When the Node enters service mode, this script should then be executed. The Node must be in service mode to execute the
script.
Perform the following steps after the script is run:
1. Remove both power cables from the DPE.
2. Once the node is powered off, insert the other Node into the DPE.
3. Plug in both power cables and boot both nodes.
The system should boot normally.
Usage
Function
Diagnostic
Mode Normal or Service
Usage Service
Requires service user password? No
Requires root privileges? No
May cause data unavailability? No
May cause data loss? No
Scope Cluster
Prerequisites The firewall must be configured correctly.
Format
svc_replace_dpe [-h] [-d] {auto,manual}
Optional arguments
Qualifier
Description
-h, --help Show the help message and exit.
-d,--debug Increase logging level to debug and print logs to console.
Service Commands 83