Setup Guide
Validation Config File Impact Severity Refer to Section
Maximum I/O size for ssd driver for
Solaris 10, 11-11.3 (SPARC)
ssd_max_xfer_size=0x100000;
ssd.conf Stability Mandatory Updating ssd.conf
configuration file
Maximum I/O size for sd driver for
Solaris 11.4 (SPARC) 11.x (x86)
sd_max_xfer_size=0x100000;
sd.conf Stability Mandatory Updating sd.conf
configuration file
Soaris ssd driver tuning for Solaris 10,
11-11.3 (SPARC)
ssd-config-list = "DellEMC
PowerStore","throttle-
max:64, physical-block-
size:4096, disksort:false,
cache-nonvolatile:true";
ssd.conf Stability Recommended Updating ssd.conf
configuration file
Soaris sd driver tuning for Solaris 11.4
(SPARC) 11.x (x86)
sd-config-list = "DellEMC
PowerStore","throttle-
max:64, physical-block-
size:4096, disksort:false,
cache-nonvolatile:true";
sd.conf Stability Recommended Updating sd.conf
configuration file
Solaris MPxIO multi-path driver tuning
load-balance="round-robin";
auto-failback="enable";
scsi_vhci.conf Stability Mandatory Updating scsi_vhci.conf
configuration file
Solaris MPxIO multi-path driver tuning
scsi-vhci-update-pathstate-
on-reset = "DellEMC
PowerStore", "yes";
scsi_vhci.conf Stability Mandatory Updating scsi_vhci.conf
configuration file
Host Fibre Channel HBA configuration
This section describes the recommended configuration to apply when attaching a host to thePowerStore cluster using host
Fibre Channel HBAs.
NOTE:
When using Fibre Channel with PowerStore, the FC HBA (Host Bus Adapters) issues described in this section
should be addressed for optimal performance.
NOTE: Before you proceed, review Fibre Channel SAN Guidelines.
Pre-Requisites
Before installing HBAs in a Solaris host, the following pre-requisites should be met:
● Follow Oracle's recommendations for installation and setup of the appropriate HBA for your system.
● It is recommended to install the latest driver version (patch), as described on the Oracle support site for each specific FC
HBA.
● Refer to the E-Lab Interoperability Navigator (http://elabnavigator.emc.com) for supported FC HBA models and drivers.
Host Configuration for Solaris
45