Setup Guide

4. Create a management VLAN.
interface vlan 100
description managementNetwork
no shutdown
exit
5. If performing remote discovery, optionally configure an ethernet interface on the switch for the remote discovery
workstation.
interface ethernet 1/1/1
description discoveryWorkstation
switchport access vlan 100
no shutdown
exit
6. Configure the management IP address for the switch.
NOTE: The following command sample assumes that automatic IP assignment through Dynamic Host Configuration
Protocol (DHCP) is enabled on the switch. If automatic IP assignment through DHCP is not enabled, then you do not
need to include no ip address dhcp in the commands below.
interface mgmt 1/1/1
no shutdown
no ip address dhcp
ip address 100.0.100.50/24
exit
7. Configure the management route (default gateway) for the switch.
management route 0.0.0.0/0 100.0.100.1
exit
8. Configure an NTP server for the switch.
ntp server 100.0.100.200
exit
9. Configure ethernet ports on the switch that will connect to the PowerStore T model management ports.
interface ethernet 1/1/2
description "PowerStoreNodeA_MgmtPort"
no shutdown
switchport mode access
switchport access vlan 100
exit
interface ethernet 1/1/53
description "PowerStoreNodeB_MgmtPort"
no shutdown
switchport mode access
switchport access vlan 100
exit
10. Create the port-channel for the uplinks.
interface port-channel 10
description Uplink
no shutdown
switchport mode trunk
switchport access vlan 1
switchport trunk allowed vlan 100
exit
interface ethernet 1/1/25
description Uplink_Ports
no shutdown
Configuring Dell PowerSwitch Series for deployments with ToR switches
55