Administrator Guide

IPv6 Routing 1413
Configuring IPv6 Routing Features (CLI)
This section provides information about the commands used for configuring
IPv6 routing on the switch. For more information about the commands, see
the
Dell Networking N1500, N2000, N3000, and N4000 Series Switches CLI
Reference Guide
at www.dell.com/support.
Configuring Global IP Routing Settings
Beginning in Privileged EXEC mode, use the following commands to
configure various global IP routing settings for the switch.
Command Purpose
configure Enter global configuration mode.
sdm prefer dual-ipv4-
and-ipv6 default
Select a Switch Database Management (SDM) template
to enable support for both IPv4 and IPv6. Changing the
SDM template requires a system reload.
ipv6 unicast-routing Globally enable IPv6 routing on the switch.
ipv6 hop-limit
limit Set the TTL value for the router. The valid range is 0 to
255.
ipv6 icmp error-interval
burst-interval [ burst-
size
]
Limit the rate at which IPv4 ICMP error messages are sent.
• burst-interval — How often the token bucket is
initialized (Range: 0–2147483647 milliseconds).
•
burst-size — The maximum number of messages that
can be sent during a burst interval (Range: 1–200).
exit Exit to Privileged EXEC mode.