Administrator Guide

426 Managing General System Settings
power inline {auto |
never}
Set the PoE device discovery admin mode.
• auto — Enables the device discovery protocol and, if
found, supplies power to the device.
•
never — Disables the device discovery protocol and stops
supplying power to the device.
power inline priority
{critical | high | low}
Configures the port priority level for the delivery of power
to an attached device.
power inline high-power Configure the port high-power mode for connected-device
compatibility. This setting is enabled by default.
power inline four-pair Enable power feed on all pairs. High-power mode must
also be enabled on the port.
power inline powered-
device type
Provide a description to represent the type of device
connected to the port.
power inline reset (Optional) Reset the port. You might use this command if
the port is stuck in an Error state.
CTRL + Z Exit to Privileged EXEC mode.
show power inline Display PoE information for the switch.
show power inline
interface
Display PoE information for the specified interface.
Command Purpose