Users Guide

1666 IPv4 and IPv6 Multicast
Configuring and Viewing PIM-DM for IPv6 Multicast Routing
Use the following commands to configure PIM-DM for IPv6 multicast
routing on the switch and on VLAN routing interfaces and to view PIM-DM
information.
Command Purpose
configure Enter global configuration mode.
ipv6 unicast-routing Enable IPv6 routing. IPv6 routing is required for
the operation of PIM.
ipv6 pim dense-mode Enable PIM-DM on the switch. Enabling IPv6
PIM enables MLD.
ip multicast-routing Enable IPv6/IPv6 multicast routing.
interface vlan vlan-id Enter Interface Configuration mode for the
specified VLAN.
ipv6 pim Enable PIM on the VLAN interface. This
command also enables MLD on the interface.
ipv6 enable Enable IPv6 on the VLAN.
ipv6 pim hello-interval seconds Specify the number of seconds (range: 0–65535)
to wait between sending PIM hello messages on
the interface.
exit Exit to Privileged Exec mode.
show ipv6 pim View system-wide PIM information.
show ipv6 pim interface vlan
vlan-id
View the PIM information for the specified
interface.
show ipv6 pim neighbor
[interface vlan vlan-id | all]
View a summary or all the details of the multicast
table.