Users Guide

Stacking 261
Managing the Stack (CLI)
This section provides information about the commands for managing the
stack and viewing information about the switch stack. For more information
about these commands, see the Dell EMC Networking N1100-ON, N1500,
N2000, N2100-ON, N3000, N3100-ON, and N4000 Series Switches CLI
Reference Guide at www.dell.com/support.
Configuring Stack Member, Stack Port, SFS and NSF Settings
Use the following commands to configure stacking and SFS settings.
Command Purpose
configure Enter Global Configuration mode.
switch current_ID
renumber new_ID
Change the switch ID number.
Changing the ID number causes all switches in the stack
to be reset to perform stack master renumbering. The
running configuration is cleared when the units reset.
stack Enter Global Stack Configuration mode.
initiate failover Move the management switch functionality from the
master switch to the standby switch.
standby unit Specify the stack member that will come up as the
master if a stack failover occurs.
set description unit
<text>
Configure a description for the specified stack member.