Users Guide

726 Access Control Lists
Configuring ACLs (CLI)
This section provides guidelines for the commands you use to create and
configure ACLs. For a complete description of the commands, see the Dell
EMC Networking N1100-ON, N1500, N2000, N2100-ON, N3000, N3100-
ON, and N4000 Series Switches CLI Reference Guide at
www.dell.com/support.
Configuring an IPv4 ACL
Use the following commands to create an IPv4 ACL, configure rules for the
ACL, and bind the ACL to an interface.
NOTE: The ip access-group command can be issued in Global Configuration
mode or Interface configuration mode. If it is applied in Global Configuration
mode, the ACL binding is applied to all interfaces. If it is applied in Interface
Configuration mode, it is applied only to the specified interfaces within the mode.
Command Purpose
configure Enter global configuration mode.
ip access-list name Create an extended ACL and enter IPv4 access-list
configuration mode.