Users Guide

Security Commands 1081
console(config-macal)# exit
console(config) # management access-class mlist
no priority (management)
Use the no priority command to remove a permit or deny condition from a
Management Access list.
Syntax
no priority priority
priority-value—The priority of the permit or deny rule to be removed. The
range is 1 to 64.
Default Configuration
This command has no default configuration.
Command Mode
Management Access-list Configuration mode
User Guidelines
A rule with the specified priority-value must exist in order to be removed.
Command History
Command introduced in version 6.5 firmware.
permit (management)
Use the permit command in Management Access-List configuration mode to
set conditions for allowing packets to flow to the switch management
function.
Syntax
permit ip-source ip-address [mask mask | prefix-length] [gigabitethernet
unit/slot/port | vlan vlan-id | port-channel port-channel-number |
tengigabitethernet unit/slot/port |fortygigabitethernet unit/slot/port][
service service ] [ priority priority-value ]