Users Guide

Layer 3 Routing Commands 1410
Example
console#show ip bgp summary
IPv4 Routing .................................. Enable
BGP Admin Mode ................................ Enable
BGP Router ID ................................. 0.0.0.100
Local AS Number ............................... 65001
Traps ......................................... Disable
Maximum Paths ................................. 1
Maximum Paths iBGP ............................ 1
Default Keep Alive Time ....................... 30
Default Hold Time ............................. 90
Number of Network Entries ..................... 3
Number of AS Paths ............................ 0
Dynamic Neighbors Current/High/Limit .......... 1/1/20
Default Metric ................................ Not Configured
Default Route Advertise ....................... No
Redistributing:
Source Metric Dist List Route Map
--------- ---------- -------------------------------- ----------------------
static
ospf 300
ospf match: int
Neighbor ASN MsgRcvd MsgSent State Up/Down Time Pfx Rcvd
---------------- ----- -------- -------- ------------- -------------- ------
10.10.10.10 65000 2269 4666 ESTABLISHED 0:00:17:15 0
show ip bgp template
The show ip bgp template command lists the routes that are allowed by the
specified community list.
Syntax
show ip bgp template [ template-name ]
• template-name—(Optional) Limits the output to a single template
Default Configuration
There is no default configuration for this command.