Users Guide

Layer 3 Routing Commands 1412
Syntax
show ip bgp [vrf vrf-name] traffic
• vrf vrf-name — Displays the aggregate address information associated
with the named VRF.
Default Configuration
By default, information about the global VRF is shown.
Command Mode
User Exec mode, Privileged Exec mode, Global Configuration mode and all
sub-modes.
User Guidelines
If the vrf-name argument is specified, information pertaining to that VRF is
displayed.
The output shows when BGP counters were last cleared (using clear ip bgp
counters). Clearing counters resets all values in this output to 0 except for the
high water mark for the work queues.
The first table lists the number of BGP messages of each type that this router
has sent and received. Following the table is a maximum send and receive
UPDATE message rate. These rates report the busiest one-second interval.
The queue statistics table reports information for BGP work queues. Items
placed on each of these work queues are as follows:
• The Events queue includes most timer events and configuration changes.
• The Keepalive Tx queue includes timer events to send a KEEPALIVE
message to a peer. The Dec Proc queue includes events that cause the
decision process to be run.
• The Rx Data queue holds incoming BGP messages.
• The RTO Notifications queue includes best route change and next hop
resolution change notifications from the routing table.
• The MIB Queries queue includes pending SNMP queries for BGP status.
Command History
Introduced in version 6.2.0.1 firmware.