Users Guide

Layer 3 Routing Commands 1537
The VRF parameter is only available on the N3000/N3100/N4000 series
switches.
The command displays the following information.
Parameter Description
BGP Section:
Routing Protocol BGP.
Router ID The router ID configured for BGP.
Local AS Number The AS number that the local router is in.
BGP Admin Mode Whether BGP is globally enabled or disabled.
Maximum Paths The maximum number of next hops in an internal or external
BGP route.
Distance The default administrative distance (or route preference) for
external, internal, and locally-originated BGP routes. The table
that follows lists ranges of neighbor addresses that have been
configured to override the default distance with a neighbor-
specific distance. If a neighbor’s address falls within one of
these ranges, routes from that neighbor are assigned the
configured distance. If a prefix list is configured, then the
distance is only assigned to prefixes from the neighbor that are
permitted by the prefix list.
Prefix List In The global prefix list used to filter inbound routes from all
neighbors.
Prefix List Out The global prefix list used to filter outbound routes to all
neighbors.
Neighbors A list of configured neighbors and the inbound and outbound
policies configured for each.
OSPFv2 Section
Routing Protocol OSPFv2.
Router ID The router ID configured for OSPFv2.
OSPF Admin Mode Whether OSPF is enabled or disabled globally.
Maximum Paths The maximum number of next hops in an OSPF route.
Routing for
Networks
The address ranges configured with an OSPF network
command.