Users Guide

Layer 3 Routing Commands 1767
Syntax
area area-id virtual-link router-id [hello-interval seconds] [retransmit-
interval seconds] [transmit-delay seconds] [dead-interval seconds]
no area area-id virtual-link router-id id [hello-interval] [retransmit-interval]
[transmit-delay] [dead-interval]
• area-id—Valid OSPFv3 area identifier (or decimal value in the range of 0-
4294967295).
• router-id—Identifies the Router ID or valid IP address of the neighbor.
• hello-interval seconds—Number of seconds to wait before sending hello
packets to the OSPF virtual interface. (Range: 1–65535)
• dead-interval seconds—Number of seconds to wait before the OSPF
virtual interface on the virtual interface is assumed to be dead. (Range: 1–
65535)
• retransmit-interval seconds—The number of seconds to wait between
retransmitting LSAs if no acknowledgment is received. (Range: 0–3600)
• transmit-delay seconds—Number of seconds to increment the age of the
LSA before sending, based on the estimated time it takes to transmit from
the interface. (Range: 0–3600)
Default Configuration
Parameter Default
area-id No area ID is predefined.
router-id No router ID is predefined.
hello-interval
seconds
10 seconds
retransmit-interval
seconds
5 seconds
transmit-delay
seconds
1 second
dead-interval
seconds
40 seconds