Users Guide

Layer 3 Routing Commands 1793
Syntax
show ipv6 ospf [area-id]
area-id — Identifier for the OSPF area being displayed.
Default Configuration
This command has no default configuration.
Command Mode
User Exec, Privileged Exec mode, Global Configuration mode and all
Configuration submodes
User Guidelines
Some of the information below displays only if you enable OSPF and
configure certain features. The following fields may be displayed:
Field Description
Router ID A 32-bit integer in dotted decimal format identifying the router
about which information is displayed. This is a configured value.
OSPF Admin
Mode
Shows whether OSPF is administratively enabled or disabled.
External LSDB
Limit
Shows the maximum number of non-default external LSAs
entries that can be stored in the link-state database.
Exit Overflow
Interval
Shows the number of seconds that, after entering
OverflowState, as defined by RFC 1765, a router will attempt to
leave OverflowState.
AutoCost Ref BW The configured autocost reference bandwidth. This value is used
to determine the OSPF metric on its interfaces. The reference
bandwidth is divided by the interface speed to compute the
metric.
Default Passive
Setting
When enabled, OSPF interfaces are passive by default.
Maximum Paths Shows the maximum number of paths that OSPF can report for
a given destination.
Default Metric Default metric for redistributed routes.