Users Guide

Switch Management Commands 1930
!Current Configuration:
!System Description “Dell Networking N4032, 6.0.0.0, Linux 2.6.32.9"
!System Software Version 6.0.0.0
!Cut-through mode is configured as disabled
!
configure
slot 1/0 1 ! Dell Networking N4032
stack
member 1 1 ! N4032
exit
interface vlan 1
exit
snmp-server engineid local 800002a203001122334455
exit
show bootvar
Use the show bootvar command in User Exec mode to display the active
system image file that the device loads at startup.
Syntax
show bootvar [unit]
• unit —Unit number.
Default Configuration
This command has no default configuration.
Command Mode
User Exec mode, Global Configuration mode and all Configuration
submodes
User Guidelines
This command has no user guidelines.
Example
The following example displays the active system image file that the device
loads at startup.
console(config)#show bootvar