Users Guide

Switch Management Commands 2200
<189>1 2013-06-13T23:24:15.652+5:30Z 10.130.185.84 TRAPMGR trapTask
traputil.c(721) 11698 [stk@674 unit:1][sev@674 NOTE] %% Link Down: Gi1/0/11
logging snmp
Use the logging snmp command in Global Configuration mode to enable
SNMP Set command logging. To disable, use the no form of this command.
Syntax
logging snmp
no logging snmp
Default Configuration
By default, logging snmp is disabled.
Command Mode
Global Configuration mode
User Guidelines
To see SNMP Set command logs use the show logging command.
Example
console(config)#logging snmp
logging source-interface
Use the logging source-interface command to select the interface from which
to use the IP address in the source IP address field of transmitted SYSLOG
packets. Use the no form of the command to revert to the default IP address.
Syntax
logging source-interface {loopback loopback-id} | {tunnel tunnel-id} |
{vlan vlan-id} | {out-of-band }
no logging source-interface
• loopback-id — The name of a loopback interface.
• tunnel-id — The name of a tunnel-id.