Users Guide

Switch Management Commands 2220
no cut-through mode
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration
User Guidelines
Cut-through mode is only supported on Dell EMC Networking N4000 series
switches. It is not supported on Dell EMC Networking N1100-
ON/N1500/N2000/N2100-ON/N3000/N3100-ON Series switches.
Example
console(config)#cut-through mode
The mode (enable) is effective from the next reload of Switch/Stack.
disconnect
Use the disconnect command to detach a UI session.
Syntax
disconnect { session-id | all }
Default Configuration
This command has no default configuration.
Command Mode
Privileged Exec mode.
User Guidelines
This command forcibly logs out and disconnects a Telnet, SSH, HTTP or
HTTPs session. Use the show sessions command to display the session
identifier.
The session identifier ranges from 0-42. The all parameter disconnects all
telnet, SSH, HTTP or HTTPs sessions.