Users Guide

Layer 2 Switching Commands 405
console#show interfaces po1
Intf Ports Ch-Type Hash Min-link Local Prf TX Util RX Util
---- ----------------------- -------- ---- -------- --------- ------- -------
Po1 Active: Te1/0/1, Te1/0/2 Dynamic 7 1 Disabled 432344 83782
Utilization is shown in Mbps.
Hash Algorithm Type
1 - Source MAC, VLAN, EtherType, source module and port Id
2 - Destination MAC, VLAN, EtherType, source module and port Id
3 - Source IP and source TCP/UDP port
4 - Destination IP and destination TCP/UDP port
5 - Source/Destination MAC, VLAN, EtherType, source MODID/port
6 - Source/Destination IP and source/destination TCP/UDP port
7 - Enhanced hashing mode
show interfaces advertise
Use the show interfaces advertise command to display information about
auto-negotiation advertisement. The display includes the local configuration
and link partner advertisement, in addition to the local advertisement.
Syntax
show interfaces advertise [{gigabitethernet unit/slot/port |
tengigabitethernet unit/slot/port | fortygigabitethernet unit/slot/port}]
Default Configuration
This command has no default configuration.
Command Mode
Privileged Exec mode, Global Configuration mode and all Configuration
submodes
User Guidelines
The priority resolution field indicates the auto-negotiated link speed and
duplex. The clock field indicates whether the local interface has auto-
negotiated to clock master or clock slave. When the link is down, the field will
show No link.
When the link is down, the Oper Peer Advertisement and Priority
Resolution fields will show dashes.