Users Guide

Layer 2 Switching Commands 641
Example #1
console#show interfaces port-channel 1
Channel Ports Ch-Type Hash Type Min-links Local Prf
------- ----------------------------- -------- ---------- --------- --------
Po1 Inactive: Gi1/0/1, Gi1/0/2, Dynamic 3 1 Enabled
Gi1/0/3, Gi1/0/4
Hash Algorithm Type
1 - Source MAC, VLAN, EtherType, source module and port ID
2 - Destination MAC, VLAN, EtherType, source module and port ID
3 - Source IP and source TCP/UDP port
4 - Destination IP and destination TCP/UDP port
5 - Source/Destination MAC, VLAN, EtherType, source MODID/port
6 - Source/Destination IP and source/destination TCP/UDP port
7 - Enhanced hashing mode
show lacp
Use this command to display LACP information for Ethernet ports.
Syntax
show lacp {gigabitethernet unit/slot/port| tengigabitethernet unit/slot/port |
fortygigabitethernet unit/slot/port}[parameters | statistics]
Parameter Description
Channel Number of the port channel to show. This parameter is
optional. If the port channel number is not given, all the
channel groups are displayed. (Range: Valid port-channel
number, 1 to 48).
• Ports—The ports that are members of the port-channel.
• Ch-Type—The aggregation scheme. Dynamic indicates that
the LACP protocol is run.
• Hash Algorithm Type—The hashing used to assign a
conversation to a particular aggregation link.
•
Local Prf — An additional field added to support the display
of the local preference.