Users Guide

Security Commands 934
acct-port
Use the acct-port command to set the port on which the RADIUS accounting
server listens for connections. Use the no form of this command to reset the
port to the default.
Syntax
acct-port port
no acct-port
• port — The layer 4 port number of the accounting server (Range: 1 -
65535).
Default Configuration
The default value of the port number is 1813.
Command Mode
RADIUS Server Accounting mode
attribute 6 priority radius server source-
interface
attribute 8 radius server attribute 4 radius server timeout
attribute 25 radius server attribute 6 radius server vsa send
authentication
attribute 31 radius server attribute 8 retransmit
attribute 168 include-in-
access-req
radius server attribute 25 show aaa servers
authentication event fail
retry
radius server attribute 31 show radius statistics
auth-port radius server attribute 168 source-ip
automate-tester radius server deadtime timeout
deadtime radius server usage
key radius server key
–
msgauth radius server retransmit –