Users Guide

Security Commands 937
Command History
Introduced in version 6.3.0.1 firmware.
Example
console#conf
console(config)#radius server auth 4.3.2.1
console(config-auth-radius)#attribute 8 include-in-access-req
attribute 25
Use the attribute 25 command to enable the switch to send the RADIUS
Class attribute as supplied by the RADIUS server in accounting messages
sent to the specific accounting server.
Syntax
attribute 25 include-in-access-req
no attribute 25 include-in-access-req
Default Configuration
By default, the Class attribute is included in the accounting messages sent to
the accounting server if received in the Access-Accept from the RADIUS
authentication server.
Command Mode
RADIUS Server Configuration
User Guidelines
The switch sends the Class attribute value supplied by the RADIUS server in
the Access-Accept message if enabled. If disabled, the Class attribute
received from the RADIUS server is ignored. The Class attribute may be up to
16 octets in length
Command History
Introduced in version 6.3.0.1 firmware.