Administrator Guide

Dell EMC Networking CLI 98
Command Groups
The system commands can be broken down into three sets of functional
groups: Layer 2, Layer 3, and Utility.
Table 1-1. System Command Groups
Command Group Description
Layer 2 Commands
ACL
Configures and displays ACL information.
MAC Address Table Configures bridging address tables.
Auto-VoIP Configures Auto VoIP for IP phones on a switch.
CDP Interoperability Configures Cisco
®
Discovery Protocol (CDP).
DHCP L2 Relay Enables the Layer 2 DHCP Relay agent for an interface.
DHCP Snooping Configures DHCP snooping and displays DHCP
Snooping information.
Dynamic ARP Inspection Configures for rejection of invalid and malicious ARP
packets.
Ethernet Configuration Configures all port configuration options for example
ports, storm control, port speed and auto-negotiation.
Ethernet CFM Configures and displays GVRP configuration and
information.
Green Ethernet Configures Green Ethernet and displays Green Ethernet
information.
GVRP Configures GVRP snooping and displays GVRP
information.
IGMP Snooping Configures IGMP snooping and displays IGMP
configuration and IGMP information.
IGMP Snooping Querier Configures IGMP Snooping Querier and displays IGMP
Snooping Querier information.
Interface Error Disable
and Auto Recovery
Automatically disables an interface when an error is
detected. Auto recovery re-enables the interface after the
configured time interval expires.
IP Addressing Configures and manages IP addresses on the switch.