Administrator Guide

Security Commands 1021
Captive Portal Configuration Commands
The commands in this section are related to captive portal configurations.
block
Use the block command to block all traffic for a captive portal configuration.
Use the “no” form of this command to unblock traffic.
Syntax
block
no block
Default Configuration
Traffic is not blocked by default.
Command Mode
Captive Portal Instance mode.
User Guidelines
There are no user guidelines for this command.
Example
console(config-cp 2)#block
configuration
Use the configuration command to enter the captive portal instance mode.
The captive portal configuration identified by CP ID 1 is the default CP
configuration. The system supports a total of ten CP configurations. Use the
“no” form of this command to delete a configuration. The default
configuration (1) cannot be deleted.
Syntax
configuration cp-id
no configuration cp-id