Administrator Guide

Dell EMC Networking CLI 111
Ethernet Configuration
ip arp inspection limit Configures the rate limit and burst interval
values for an interface.
IC
ip arp inspection trust Configures an interface as trusted for Dynamic
ARP Inspection.
IC
ip arp inspection validate Enables additional validation checks like source
MAC address validation, destination MAC
address validation or IP address validation on
the received ARP packets.
GC
ip arp inspection vlan Enables Dynamic ARP Inspection on a single
VLAN or a range of VLANs.
GC
permit ip host mac host Configures a rule for a valid IP address and
MAC address combination used in ARP packet
validation.
ARPA
show arp access-list Displays the configured ARP ACLs with the
rules.
PE
show ip arp inspection Displays the Dynamic ARP Inspection
configuration.
PE
12 Enabled Disabled Displays the Dynamic ARP Inspection
configuration on all the VLANs in the given
VLAN range.
PE
a. For the meaning of each Mode abbreviation, see Mode Types .
Command Description Mode
a
clear counters Clears statistics on an interface or globally. PE
description Adds a description to an interface. IC
default (interface) Configures the interface to the defaults. GC
duplex Configures the duplex operation of a given
Ethernet interface
IC
flowcontrol Configures the flow control on a given interface. GC or
IC
Command Description Mode
a