Administrator Guide

Layer 3 Routing Commands 1365
Default Hold Time ............................. 90
Number of Network Entries ..................... 0
Number of AS Paths ............................ 0
Dynamic Neighbors Current/High/Limit .......... 1/1/20
Default Metric ................................ Not Configured
Default Route Advertise ....................... No
Redistributing:
Source Metric Dist List Route Map
--------- ---------- -------------------------------- ----------------------
Neighbor ASN MsgRcvd MsgSent State Up/Down Time Pfx Rcvd
---------------- ----- -------- -------- ------------- -------------- ------
fe80::21e:c9ff:fede:b13a%Vl10
65000 137 136 ESTABLISHED 0
show bgp ipv6 update-group
Use this command to report the status of IPv6 outbound groups and their
members. Output and format are the same as for show ip bgp update-group.
This command deprecates and replaces the show ipv6 bgp update-group
command.
Syntax
show bgp ipv6 update-group [ group-index | ipv4-address | ipv6-address [
interface interface-id ] | autodetect interface interface-id ]
• group-index—If specified, this option restricts the output to a single
update group.
• ipv4-address—The IPv4 address of a peer enabled for exchange of IPv6
prefixes. If specified, this option restricts the output to the update group
containing the peer with the given address.
• ipv6-address [ interface interface-id ]—The IPv6 address of a peer. If the
peer address is a link local address, the interface that defines the scope of
the address must also be given. If a peer address is specified, this option
restricts the output to the update group containing the peer with the given
address.
• autodetect interface interface-id —(Optional) The routing interface on
which the neighbor’s link local IPv6 address is auto detected. The
interface-id must be a VLAN routing interface.