Administrator Guide

Layer 3 Routing Commands 1377
• vrf vrf-name — Displays the aggregate address information associated
with the named VRF.
Default Configuration
By default, information about the global VRF is shown.
Command Mode
User Exec mode, Privileged Exec mode, Global Configuration mode and all
sub-modes.
User Guidelines
Since IPv4 prefixes can only be exchanged over IPv4 peering, the neighbor-
address parameter must be an IPv4 peer address. This option limits the
output to show a single neighbor. If no neighbor address is specified, the
command shows all neighbors enabled for IPv4 prefix exchange.
If the vrf-name argument is specified, information pertaining to that VRF is
displayed.
The following fields are displayed.
Field Description
Remote Address The neighbor’s IP address
Remote AS The neighbor’s autonomous system number
Peer ID The neighbor’s BGP router ID
Peer Admin Status START or STOP
Peer State The adjacency state of this neighbor
Local Port TCP port number on the local end of the connection
Remote Port TCP port number on the remote end of the connection
Connection Retry Interval How long BGP waits between connection retries