Administrator Guide

Layer 3 Routing Commands 1590
Default Configuration
This command has no default configuration.
Command Mode
Privileged Exec mode, Global Configuration mode and all Configuration
submodes
User Guidelines
This command has no user guidelines.
Example
The following example displays IPv6 VLAN routing interface addresses.
console#show ipv6 vlan
MAC Address used by Routing VLANs: 00:02:BC:00:30:68
VLAN ID IPv6 Address/Prefix Length
------- ---------------------------------------
1
traceroute ipv6
Use the traceroute ipv6 command to determine the path and measure the
transit delay to another device in the network. The transit delays are
measured for each hop in the network.
Syntax
traceroute ipv6 {ipv6-address|hostname} [count 1-10] [init-ttl 1-255]
[interval 1-60] [max-fail 0-255] [max-ttl 1-255] [port 1-65535] [size 0-
39936] [source {ipv6-address | loopback loopback-id| vlan vlan-id}]
• ipv6-address | hostname—The target IP address or host to ping.
• out-of-band—Send the ping over the out-of-band interface.
• vlan-id—The VLAN over which to send the echo request.
• loopback-id—Use the source address from the selected loopback. (Range
0-7)
• count—The number of echo request packets to send for each ttl value.
(Range 1-10. Default 3).