Administrator Guide

Dell EMC Networking CLI 162
bgp cluster-id Specifies the cluster ID of a route reflector. BR
bgp default local-preference Enables the network operator to specify the
default local preference.
BR
bgp fast-external-fallover Configures BGP to immediately reset the
adjacency with an external peer if the routing
interface to the peer goes down.
BR
bgp fast-internal-fallover Configures BGP to immediately reset the
adjacency with an internal peer when there is a
loss of reachability to an internal peer.
BR
bgp listen Creates an IPv4 listen range and associates it
with the specified peer template.
BR,
IPAF
bgp log-neighbor-changes Enables logging of adjacency state changes. BR
bgp maxas-limit Specifies a limit on the length of AS Paths that
BGP accepts from its neighbors.
BR
bgp router-id Sets the BGP router ID. BR
clear ip bgp Resets peering sessions with all of a subnet of
BGP peers.
PE
clear ip bgp counters Resets all BGP counters to 0. PE
default-information
originate (BGP Router
Configuration)
Enables BGP to originate a default route. BR
default-information
originate (IPv6 Address
Family Configuration)
Allows BGP to originate an IPv6 default route. IPAF
default metric (BGP Router
Configuration)
Sets the value of the MED attribute on routes
redistributed into BGP when no metric has
been specified.
BR
default metric (IPv6 Address
Family Configuration)
Sets the metric of redistributed IPv6 routes
when a metric is not configured in the
redistribute command.
IPAF
distance Sets the preference of BGP routes to specific
destinations.
IPAF
Command Description Mode
a