Administrator Guide

Layer 3 Routing Commands 1715
User Guidelines
The VRF identified in the parameter must have been previously created or an
error is returned.
The VRF parameter is only available on the N3000/N3100/N4000 series
switches.
Example
console#show ip ospf asbr
Type Router Id Cost Area ID Next Hop Next Hop
Intf
----- ---------- ---- -------- ----------- -----------
INTRA 1.1.1.1 1 0.0.0.1 10.1.12.1 vlan10
INTRA 4.4.4.4 10 0.0.0.1 10.1.24.4 vlan12
show ip ospf database
Use the show ip ospf database command to display information about the
link state database when OSPF is enabled. If parameters are entered, the
command displays the LSA headers. Use the optional parameters to specify
the type of link state advertisements to display.
Syntax
show ip ospf [vrf vrf-name] [ area-id ] database [{asbr-summary | external |
network | nssa-external | router | summary}][ls-id] [adv-router [ip-address]
| self-originate] [opaque-area] [opaque-as] [opaque-link]
• vrf-name—The name of the VRF instance on which the command
operates. If no VRF parameter is given, information for the default
(global) router instance is shown.
• area-id — Identifies a specific OSPF area for which link state database
information will be displayed.
• asbr-summary — Display the autonomous system boundary router (ASBR)
summary LSAs.
• external — Display the external LSAs.
• network — Display the network LSAs.
• nssa-external — Display NSSA external LSAs.
• router — Display router LSAs.