Administrator Guide

Layer 3 Routing Commands 1763
console(config-if-vlan15)#ipv6 ospf cost 100
ipv6 ospf dead-interval
Use the ipv6 ospf dead-interval command in Interface Configuration mode
to set the OSPF dead interval for the specified interface.
Syntax
ipv6 ospf dead-interval seconds
no ipv6 ospf dead-interval
seconds — A valid positive integer, which represents the length of time in
seconds that a router's Hello packets have not been seen before its
neighbor routers declare that the router is down. The value for the length
of time must be the same for all routers attached to a common network.
This value should be some multiple of the Hello Interval (i.e. 4).
(Range: 1-65535)
Default Configuration
40 seconds is the default value of seconds.
Command Mode
Interface Configuration (VLAN, Tunnel, Loopback) mode.
User Guidelines
This command has no user guidelines.
Example
The following example sets the OSPF dead interval at 100 seconds.
console(config)#interface vlan 15
console(config-if-vlan15)#ipv6 ospf dead-interval 100
ipv6 ospf hello-interval
Use the ipv6 ospf hello-interval command in Interface Configuration mode
to set the OSPF hello interval for the specified interface.