Administrator Guide

Layer 3 Routing Commands 1783
Syntax
show ipv6 ospf border-routers
Default Configuration
This command has no default configuration.
Command Mode
User Exec, Privileged Exec mode, Global Configuration mode and all
Configuration submodes
show ipv6 ospf database
Use the show ipv6 ospf database command to display information about the
link state database when OSPFv3 is enabled.
Syntax
show ipv6 ospf [area-id] database [{external | inter-area {prefix | router} |
link | network | nssaexternal | prefix | router | unknown [area | as | link]}]
[link-state-id] [adv-router [router-id] | self-originate]
• area-id — Identifies a specific OSPF area for which link state database
information will be displayed.
• external — Displays the external LSAs.
• inter-area — Displays the inter-area LSAs.
• link — Displays the link LSAs.
• network — Displays the network LSAs.
• nssa-external — Displays NSSA external LSAs.
• prefix — Displays intra-area Prefix LSA.
• router — Displays router LSAs.
• unknown — Displays unknown area, AS or link-scope LSAs.
•l ink-state- id — Specifies a valid link state identifier (LSID).
• adv-router — Shows the LSAs that are restricted by the advertising router.
• router-id — Specifies a valid router identifier.
• self-originate — Displays the LSAs in that are self originated.