Administrator Guide

Switch Management Commands 1969
User Guidelines
Messages are shown for both the accept and reject use cases with information
directing the user to URLs for further information. If the user rejects or has
not yet accepted the EULA, the configuration mode for the specified service
is not usable. If there is existing configuration for that feature, the
configuration is not removed, but the feature is disabled.
This command can be executed multiple times. It overwrites the previous
information each time. The collected information is stored in the running-
config. The administrator must write the configuration in order to persist it
across reboots. If the administrator clears the config, this information must
be reconfigured.
Command History
Introduced in version 6.3.0.1 firmware.
Example
console(config)# eula-consent hiveagent accept
This switch includes a feature that enables it to work with HiveManager (an
optional management suite), by sending the switch’s service tag number to
HiveManager to authenticate your entitlement to use HiveManager. If you wish
to disable this feature, you should run command “eula-consent hiveagent
reject” immediately upon powering up the switch for the first time, or at any
time thereafter.
console(config)# eula-consent hiveagent reject
I do not accept the terms of the license agreement. The HiveAgent feature has
been deactivated and can no longer be used. To enable HiveAgent
configurations, accept the terms of the license agreement by configuring this
command 'eula-consent hiveagent accept'.
hiveagent
Use the hiveagent command to access the HiveAgent configuration mode.
Use the no form of the command to remove the configured Dell HiveAgent
information.
Syntax
hiveagent