Administrator Guide

Switch Management Commands 1998
console#config
console(config)#interface vlan 2
console(config-if-vlan2)#ipv6 address dhcp
ipv6 enable (Interface Configuration)
Use the ipv6 enable command in Interface Configuration mode to enable
IPv6 on a routing interface. Use the no form of this command to reset the
IPv6 configuration to the defaults.
Syntax
ipv6 enable
no ipv6 enable
Default Configuration
IPv6 is not enabled by default.
Command Mode
Interface Configuration mode (VLAN, tunnel, loopback)
User Guidelines
There are no user guidelines for this command.
Example
console(config)#no ipv6 enable
ipv6 enable (OOB Configuration)
Use the ipv6 enable command in Interface (out-of-band) Configuration
mode to enable IPv6 operation on the out-of-band interface. Prefixes
configured by the ipv6 address command are not configured until the
interface is enabled.
Syntax
ipv6 enable
no ipv6 enable