Administrator Guide

Switch Management Commands 2124
SNMP Commands
The SNMP component provides a machine-to-machine interface for the Dell
EMC Networking product family. This includes the ability to configure the
network device, view settings and statistics, and upload or download code or
configuration images. The agent includes a get-bulk command to reduce
network management traffic when retrieving a sequence of Management
Information Base (MIB) variables and an elaborate set of error codes for
improved reporting to the network control station. The extensible and
advanced design of the Dell EMC Networking SNMP makes adding remote
manageability to networked devices undemanding. The agent allows a
network control station to retrieve reports from the networked device. These
reports are based upon the defined objects in the MIB. The agent queries,
reports, and sets MIB variables based upon directions from the network
control station or upon preset conditions.
Dell EMC Networking supports IPv4 and IPv6 SNMP access. Management
access may be restricted to individual IPv4 and IPv6 management stations for
management access and traps/informs. Management access may also be
restricted to an IPv4 or IPv6 subnet.
Commands in this Section
This section explains the following commands:
show snmp snmp-server community snmp-server group
show snmp engineid snmp-server community-
group
snmp-server host
show snmp filters snmp-server contact snmp-server location
show snmp group snmp-server enable traps snmp-server user
show snmp user snmp-server engineID local snmp-server view
show snmp views snmp-server filter snmp-server v3-host
show trapflags
– snmp-server source-
interface