Administrator Guide

Layer 2 Switching Commands 559
Example
console(config)#interface gigabitethernet 1/0/1
console(config-if-Gi1/0/1)#lldp med
lldp med confignotification
This command is used to enable sending topology change notifications.
Syntax
lldp med confignotification
no lldp med confignotification
Command Mode
Interface Configuration (Ethernet) mode
Default Value
By default, notifications are disabled on all Ethernet interfaces.
User Guidelines
There are no guidelines for this command.
Example
console(config)#lldp med confignotification
lldp med faststartrepeatcount
This command is used to set the value of the fast start repeat count.
Syntax
lldp med faststartrepeatcount count
no lldp med faststartrepeatcount
• count — Number of LLDPPDUs that are transmitted when the protocol is
enabled. (Range 1–10)
Command Mode
Global Configuration