Administrator Guide

Security Commands 951
Default Configuration
By default, the switch uses the assigned switch IP address as the source IP
address for RADIUS packets. This is either the IP address assigned to the
VLAN from which the RADIUS packet originates or the out-of-band interface
IP address.
Command Mode
Global Configuration
User Guidelines
The source IP address of RADIUS packets sent to a server should match the
NAS IP address configured on the RADIUS server. A mismatch may lead to a
RADIUS packet timeout.
Loopback interfaces are not supported on the Dell EMC N1100-ON Series
switches.
Command History
Introduced in version 6.3.0.1 firmware.
Example
console#conf
console(config)#interface vlan 1
console(config-if-vlan1)#ip address dhcp
console(config-if-vlan1)#exit
console(config)#radius server source-interface vlan 1
radius server timeout
Use the radius server timeout command in Global Configuration mode to set
the interval for which a switch waits for a server to reply. To restore the
default, use the no form of this command.
Syntax
radius server timeout timeout
no radius server timeout
• timeout — Specifies the timeout value in seconds. (Range: 1–30)