Users Guide

Security Commands 1006
attribute 8
Use the attribute 8 command to configure the switch to send the RADIUS
Framed-IP-Address attribute in the Access-Request message sent to a specific
RADIUS authentication server. The switch sends the IP address of the host
attempting to authenticate in the Framed-IP-Address attribute in the Access-
Request sent to the authentication server.
Syntax
attribute 8 include-in-access-req
no attribute 8 include-in-access-req
Default Configuration
By default, the Framed-IP-Address is not included in the Access-Request
message sent to the authentication server.
Command Mode
RADIUS Server Configuration
User Guidelines
There are no user guidelines for this command.
Command History
Introduced in version 6.3.0.1 firmware.
Example
console#conf
console(config)#radius server auth 4.3.2.1
console(config-auth-radius)#attribute 8 include-in-access-req
attribute 25
Use the attribute 25 command to enable the switch to send the RADIUS
Class attribute as supplied by the RADIUS server in accounting messages
sent to the specific accounting server.