Users Guide

Security Commands 1025
Syntax
radius server attribute 25 include-in-access-req
no radius server attribute 25 include-in-access-req
Default Configuration
By default, the switch sends the Class attribute to the accounting server if
received in the Access-Accept from the RADIUS authentication server.
Command Mode
Global Configuration
User Guidelines
The switch sends the Class attribute value supplied by the RADIUS server in
the RADIUS Access-Accept message if enabled. If disabled, the Class
attribute received in the RADIUS Access-Accept message is ignored. The
Class attribute may be up to 16 octets in length
Command History
Introduced in version 6.3.0.1 firmware.
Example
console#conf
console(config)#radius server attribute 25 include-in-access-req
radius server attribute 32
Use the radius server attribute 32 command to configure the content of the
NAS-Identifier sent to the RADIUS server in Access-Request and Acct-
Request messages. Use the no form of the command to return the content to
the default.
Syntax
radius server attribute 32 include-in-access-req [format]
no radius server attribute 32 include-in-access-req