Users Guide

Layer 3 Routing Commands 1217
6
Layer 3 Routing Commands
The sections that follow describe commands that conform to the OSI model’s
Network Layer (Layer 3). Layer 3 Routing commands enable routing
protocols to perform a series of exchanges over various data links to route data
between any two nodes in a network. These commands define the addressing
and routing structure of the Internet.
The Dell EMC N1100-ON Series switches do not support routing.
This section of the document contains the following Layer 3 topics:
ARP Commands IPv6 Multicast Commands
Bidirectional Forwarding Detection
Commands
IP Service Level Agreement Commands
Border Gateway Protocol Commands OSPF Commands
BGP Routing Policy OSPFv3 Commands
DVMRP Commands IPv6 Policy-Based Routing Commands
IGMP Commands Router Discovery Protocol Commands
IGMP Proxy Commands Routing Information Protocol Commands
IP Helper/DHCP Relay Commands Tunnel Interface Commands
IP Routing Commands Unicast Reverse Path Forwarding
Commands
IPv6 Routing Commands Virtual Router Commands
Loopback Interface Commands Virtual Router Redundancy Protocol
Commands
IP Multicast Commands Virtual Router Redundancy Protocol v3
Commands