Users Guide

Dell EMC Networking CLI 123
Loop Protection
lldp receive Enables the LLDP receive capability. IC
lldp timers Sets the timing parameters for local data
transmission on ports enabled for LLDP.
GC
lldp transmit Enables the LLDP advertise capability. IC
lldp tlv-select Specifies which optional TLVs in the 802.1AB
basic management set will be transmitted in the
LLDPDUs.
IC
show lldp Displays the current LLDP configuration
summary.
PE
show lldp interface Displays the current LLDP interface state. PE
show lldp local-device Displays the LLDP local data. PE
show lldp med Displays a summary of the current LLDP MED
configuration.
PE
show lldp med interface Displays a summary of the current LLDP MED
configuration for a specific interface.
PE
show lldp med local-device
detail
Displays the advertised LLDP local data in
detail.
PE
show lldp med remote-
device
Displays the current LLDP MED remote data. PE
show lldp remote-device Displays the current LLDP remote data. PE
show lldp statistics Displays the current LLDP traffic statistics. PE
a. For the meaning of each Mode abbreviation, see Mode Types .
Command Description Mode
a
keepalive (Interface Config) Enables loop protection on an interface. IC
keepalive (Global Config) Globally enable loop protection and
optionally configure the loop protection
timer and packet count.
GC
keepalive action Configure the action taken when a loop is
detected on an interface.
IC
Command Description Mode
a