Users Guide

Layer 3 Routing Commands 1305
User Guidelines
If you assign a neighbor filter list to a nonexistent AS path access list, all
routes are filtered. The VLAN interface must also be specified if a link-local
address is specified.
Command History
Introduced in version 6.2.0.1 firmware.
Example
console(config-router-af)#neighbor FE80::0202:B3FF:FE1E:8329 interface vlan
10 filter-list 1 in
neighbor inherit peer
To configure a BGP peer to inherit peer configuration parameters from a peer
template, use the neighbor inherit peer command. To remove the
inheritance, use the no form of this command.
Syntax
neighbor { ip-address | ipv6-address [ interface interface-id ] ] | autodetect
interface interface-id} inherit peer template-name
no neighbor { ip-address | ipv6-address [ interface interface-id ] | autodetect
interface interface-id} inherit peer template-name
• ip-address—The neighbor’s IPv4 address.
• ipv6-address [interface interface-id]—The neighbor’s IPv6 address. If the
neighbor’s IPv6 address is a link local address, the local interface must also
be specified.
• autodetect interface interface-id – The VLAN routing interface on which
the neighbor’s link local IPv6 address is auto detected.
• template-name—The name of the peer template whose peer configuration
parameters are to be inherited by this neighbor.
Default Configuration
No peer configuration parameters are inherited by default.