Users Guide

Layer 3 Routing Commands 1318
no neighbor { ip-address | ipv6-address [interface vlan vlan-id] | autodetect
interface interface-id } remote-as
• ip-address—The neighbor’s IPv4 address. For external peers, this address
must be an IPv4 address on the link that connects the two peers. For
internal peers, the neighbor address can be any address, such as the IPv4
address of a loopback interface.
• ipv6-address—The neighbor’s IPv6 address. If the neighbor’s IPv6 address
is a link local address, the local interface must also be specified. This
command is available in IPv6 address family mode.
• interface vlan vlan-id—The local routing interface/VLAN ID over which
the IPv6 neighbor can be reached. Range: 1-4093.
• autodetect interface interface-id —(Optional) The routing interface on
which the neighbor’s link local IPv6 address is auto detected. The
interface-id must be a VLAN routing interface. Range is 1–4093.
• remote-as as-number—The router’s autonomous system number of the
neighbor’s AS in asplain format. Dell EMC Networking BGP supports four
byte AS numbers, in the range of 0-429496729. If the neighbor’s AS
number is the same as the local router and the peer is considered an
internal peer. Otherwise, the peer is an external peer.
Default Configuration
No neighbors are configured by default.
Command Mode
BGP Router Configuration mode
IPv4 Address Family Configuration mode
User Guidelines
Up to 100 neighbors can be configured.
Command History
Introduced in version 6.2.0.1 firmware. Updated in version 6.3.0.1 firmware.
Command updated in version 6.6 firmware.