Users Guide

Layer 3 Routing Commands 1324
Example
console(config-router-af)#neighbor 10.130.14.55 route-map test in
neighbor route-reflector-client (BGP Router
Configuration)
To configure an internal peer as an IPv4 route reflector client, use the
neighbor route-reflector-client command.
Syntax
neighbor ip-address route-reflector-client
no neighbor ip-address route-reflector-client
• ip-address—The neighbor’s IPv4 address.
Default Configuration
Peers are not route reflector clients by default.
Command Mode
BGP Router Configuration
User Guidelines
Normally, a router does not re-advertise BGP routes received from an internal
peer to other internal peers. If you configure a peer as a route reflector client,
this router will re-advertise such routes. A router is a route reflector if it has
one or more route reflector clients. Configuring the first route reflector client
automatically makes the router a route reflector.
If you configure multiple route reflectors within a cluster, you must configure
each route reflector in the cluster with the same cluster ID. Use the bgp
cluster-id command to configure a cluster ID.
An external peer may not be configured as a route reflector client.
When reflecting a route, BGP ignores the set statements in an outbound
route map to avoid causing the receiver to compute routes that are
inconsistent with other routers in the AS.