Users Guide

Layer 3 Routing Commands 1353
2001::20 0 ACTIVE
Listen Range.................................. 2002::1/64
Inherited Template............................ template_2002
Member ASN State
--------------------------------------- ----- -----------
show bgp ipv6 neighbors
Use this command to display neighbors with IPv4 or IPv6 peer addresses that
are enabled for the exchange of IPv6 prefixes. This command deprecates and
replaces the show ipv6 bgp neighbors command.
Syntax
show bgp ipv6 neighbors [ ipv4-address | ipv6-address [ interface interface-
id ] | autodetect interface interface-id ]
• ipv4-address | ipv6-address —(Optional) If a peer address is specified, the
output is limited to an individual peer.
• interface-id—(Optional) If the peer address is an IPv6 link local address,
the interface that defines the scope of the link local address must be given.
This must be a VLAN routing interface.
• autodetect interface interface-id —(Optional) The routing interface on
which the neighbor’s link local IPv6 address is auto detected.
Default Configuration
There is no default configuration for this command.
Command Mode
Privileged Exec mode, Global Configuration mode and all Configuration
submodes
User Guidelines
• “RFC 5549 Support” is displayed only if the BGP neighbor is peered over
IPv6 network.