Users Guide

Layer 3 Routing Commands 1362
policy. The output and format as the same as for show IP bgp neighbors
received-routes, except that they list IPv6 routes. Also, the command displays
a list of IPv4 routes received from a specific neighbor with RFC5549.
This command deprecates and replaces the show ipv6 bgp neighbors
received-routes command.
Syntax
show bgp ipv6 neighbors { ipv4-address | ipv6-address [ interface interface-id
] | autodetect interface interface-id } { received-routes | routes | rejected-
routes }
• ipv4-address—The IPv4 address of a BGP peer
• ipv6-address interface interface-id—The IPv6 address of a BGP peer. If the
peer address is an IPv6 link local address, the interface that defines the
scope of the link local address must be given.
• autodetect interface interface-id —(Optional) The routing interface on
which the neighbor’s link local IPv6 address is auto detected. The
interface-id must be a VLAN routing interface.
Default Configuration
There is no default configuration for this command.
Command Mode
Privileged Exec and all show modes
User Guidelines
The following fields are displayed.
Field Description
Network The destination prefix.
Next Hop The BGP Next Hop as advertised by the peer.
Metric The value of the MED, if a MED is received from the
peer.
Local Pref The local preference received from the peer.
Path The AS path as received from the peer.