Users Guide

Layer 3 Routing Commands 1465
User Guidelines
This command enables IGMP proxy on the VLAN interface. Use this
command to enable sending of IGMP messages received on interfaces
configured with the ip igmp mroute-proxy command to an attached
multicast router.
PIM and DVMRP are not compatible with IGMP proxy. Disable
PIM/DVMRP before enabling IGMP proxy.
Multicast routing must be enabled for the IGMP proxy service to become
operationally enabled. This command enables IGMP/MLD. Disabling IGMP
Proxy may operationally disable multicast routing.
Example
The following example enables the IGMP Proxy on the VLAN 15 router.
console(config)#interface vlan 15
console(config-if-vlan15)#ip igmp-proxy
ip igmp proxy-service reset-status
Use the ip igmp proxy-service reset-status command in Interface
Configuration mode to reset the host interface status parameters of the
IGMP Proxy router. This command is valid only when IGMP Proxy is enabled
on the interface.
Syntax
ip igmp proxy-service reset-status
Default Configuration
This command has no default configuration.
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
This command has no user guidelines.