Users Guide

Layer 3 Routing Commands 1587
Queries Received............................... 0
Queries Sent................................... 7
Reports Received............................... 52
Reports Sent................................... 0
Leaves Received................................ 0
Leaves Sent.................................... 0
Bad Checksum MLD Packets....................... 0
Malformed MLD Packets.......................... 0
show ipv6 nd raguard policy
Use this command to display the RA Guard policy on all interfaces for which
it is enabled.
Syntax
show ipv6 nd raguard policy
Default Configuration
By default, no RA guard policies are applied to any interface.
Command Mode
Privileged Exec, Global Configuration
User Guidelines
This command has no user guidelines.
Command History
Introduced in version 6.2.0.1 firmware.
Example
The following example configures an unnamed RA Guard policy to drop all
RA advertisements and router redirect messages on interface Gi1/0/1 (VLAN
10). The configured interfaces are shown.
console(config)#vlan 10
console(config-vlan101)#exit
console(config)#interface vlan 10
console(config-if-vlan10)#ipv6 enable
console(config-if-vlan10)#exit
console(config)#ipv6 unicast-routing