Users Guide

Layer 3 Routing Commands 1632
IPv6 Multicast Commands
Dell EMC Networking N3000E-ON/N3100-ON/N3200-ON Series
Switches
The Dell Network N1500/N2000/N2100-ON/N2200-ON Series switches support
limited routing and multicast capabilities. See the Users Configuration Guide
section “Feature Limitations and Platform Constants” for supported capabilities.
clear ipv6 mroute
This command is used to selectively clear dynamic IPv6 multicast entries
from the cache.
Syntax
clear ipv6 mroute { * | group-address [ source-address ] }
* —Deletes all IPv6 entries from the IP multicast routing table.
group-address— IPv6 address of the multicast group.
source-address—IPv6 address of a multicast source that is sending multicast
traffic to the group.
Default Configuration
There is no default configuration for this command.
Command Mode
Privileged Exec mode, Global Configuration mode and all Configuration
submodes
User Guidelines
This command does not clear static multicast route entries.
When a * entry is deleted through this command, it cannot be formed again
until it is expired in MLD and started again via the host. The default mcache
time-out is 210 seconds.